Bms 13s 30a com no Interruptor de Fff Tensão de Carregamento 54.6v Bateria de Lítio Pcb Pcm 30a

1. Acessórios para Bateria e Carregador

2. Bms 13s 30a com no Interruptor de

3. Peças e Acessórios

Application and features:

A, applicable to series 13 series, 30AH and the following lithium/cobalt acid lithium/lithium cobalt/lithium/lithium polymer/triples battery pack
B, perfect overcharge protection, overdischarge protection, discharge overcurrent protection and discharge short circuit protection
C, the peripheral protection adopts the aluminum profile heat sink, which has anti-vibration, anti-fall, anti-impact and increasing heat dissipation and strength function
D, the main control IC adopts the special battery protection with high integration degree, which has reliable and stable function, low self-loss and ESD
E, has broken line protection function

4. Acessórios para Bateria e Carregador

5. Bms 13s 30a com no Interruptor de

6. Peças e Acessórios

7. Acessórios para Bateria e Carregador

8. Bms 13s 30a com no Interruptor de

The test battery must be a new battery with a production time of less than one week.

Unless otherwise specified, the test shall be carried out indoors at a temperature of about 23 degrees of camera shooting and a relative humidity of about 65. Please use a 10AH battery pack for the road test.When starting the test, please turn on the load before connecting the lead wire of the peripheral control switch

3.7v*13cell

Wiring instructions
Main line: 1, B-/TP1: the negative pole of the battery pack
2.P-/ TP2: negative pole of the discharge load
3.C-/ TP3: negative electrode of charger
Voltage test line (line of line)
.
Wiring instructions:
power cable
B-:Connect to battery negative
P-:Connect to negative of discharge port
C-:Connect to negative of charge port

Voltage monitoring cable

B-(GND)/B1/B2/B3/B4/B5/B6/B7/B8/B9/B10/B11/B12/B13(B+)

ON OFF switch : red

Remarks:
Please connect B- line firstly, and then connect voltage monitoring wiring harness. The last step is to connect charge and discharge lines. If you want to remove them, the order should be reversed. Please pay attention to the connection order, or it will damage the component.